This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › Pypilot › General discussion v
Need help with current sense/over-current detection

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Need help with current sense/over-current detection
skyeyedoc Offline
Junior Member
**
Posts: 39
Threads: 11
Joined: May 2019
Reputation: 2
#5
2019-08-28, 11:11 PM
(2019-08-28, 10:45 PM)seandepagnier Wrote: No, it does not serve the same function.
Ok.  Then should I be using a 560 ohm (R2) resistor from A1, and what does it tie to at "shunt", exactly? This is ignorance on my part, I know, but it's not obvious from the schematic, and this board is different in many respects. Maybe this IBT2 is incompatible with what I'm looking at? Thanks again for trying to help.
Elliott
Find
Reply


Messages In This Thread
RE: Need help with current sense/over-current detection - by skyeyedoc - 2019-08-28, 11:11 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)