2019-09-06, 11:55 AM
Hi All,
has anyone see a good walk through for inital setup of the Ads1115?
I have followed the stand connection guide for a i2c device and I'm showing the below,
The address of the Ads1115 is on 48, however I'm not sure if I need to add it in the i2c tab and if so are the device discriptions from the drop down OK to customise.
Or do you just start the Ads1115 service in the tools tab and setup vi the file?
Another question I had was its clear via the auto detect its seeing the A0 1,2 & 3, is it just inheriting that from the file (I'm sure for the discrptions this is true)? I guess a better question is if I pluged in two ADS1115 would I see 8 OpSensors.
![[Image: O8WnDYX.png]](https://i.imgur.com/O8WnDYX.png)
This is what I see in Signal K
![[Image: XYnHAsC.png]](https://i.imgur.com/XYnHAsC.png)
![[Image: eYFCYbl.png]](https://i.imgur.com/eYFCYbl.png)
My next step was to put a couple of volts on A0 and see if that show in Signal K?
has anyone see a good walk through for inital setup of the Ads1115?
I have followed the stand connection guide for a i2c device and I'm showing the below,
The address of the Ads1115 is on 48, however I'm not sure if I need to add it in the i2c tab and if so are the device discriptions from the drop down OK to customise.
Or do you just start the Ads1115 service in the tools tab and setup vi the file?
Another question I had was its clear via the auto detect its seeing the A0 1,2 & 3, is it just inheriting that from the file (I'm sure for the discrptions this is true)? I guess a better question is if I pluged in two ADS1115 would I see 8 OpSensors.
This is what I see in Signal K
My next step was to put a couple of volts on A0 and see if that show in Signal K?