2019-09-06, 04:15 PM
(This post was last modified: 2019-09-06, 05:32 PM by 3sheet2thewind.)
so after reworking something, I'm seeing more +VE results
From the config file below can I assume the high_voltage = 3000 is in m volts?
_[ADS1115_0] active = 1
gain = 0
samples = 6
ohmmeter = 0
fixed_resistor = 0
high_voltage = 3000
voltage_divider = 0
upper_resistance = 1000
lower_resistance = 1000
adjust = 0
sk_name = tanks.fuel.left.currentLevel
adjust_points = [[100.0,0.0],[5000.0,90.0],[9000.0,100.0]]
I just need to do some reading to understand how to match the input on the A0 etc pin to what I'm seeing in the config file above.
From the config file below can I assume the high_voltage = 3000 is in m volts?
_[ADS1115_0] active = 1
gain = 0
samples = 6
ohmmeter = 0
fixed_resistor = 0
high_voltage = 3000
voltage_divider = 0
upper_resistance = 1000
lower_resistance = 1000
adjust = 0
sk_name = tanks.fuel.left.currentLevel
adjust_points = [[100.0,0.0],[5000.0,90.0],[9000.0,100.0]]
I just need to do some reading to understand how to match the input on the A0 etc pin to what I'm seeing in the config file above.