This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rudder sensor
#1
Installed my rudder sensor.
On the tinypilot when going in to calibration, rudder it says N/a
It works calibrate in opencpn plugin signalk client, except  impossible to change rudder range to any thing it stays at 22.
Works as it should and web app under a different computer shows the same calibration.
Left on for 3 hours. Turning tinypilot off and then  restart all ruddercalibration is gone except rudder non linearity that is the same as before turning of Tinypilot.

How can I get the calibration to be saved?
Attached is signalk values when working. After restart offset and scale is zero.

Johan

   
Reply


Messages In This Thread
Rudder sensor - by Jlsail - 2019-09-10, 11:35 PM
RE: Rudder sensor - by seandepagnier - 2019-09-11, 12:39 AM
RE: Rudder sensor - by Jlsail - 2019-09-11, 02:37 PM
RE: Rudder sensor - by rastam4n - 2019-09-12, 03:52 AM
RE: Rudder sensor - by Apex - 2019-09-12, 03:53 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)