2019-11-22, 11:17 AM
(2019-11-22, 10:57 AM)Sailoog Wrote:(2019-11-21, 10:46 PM)Max1947 Wrote: Hi Sailoog, with the Glowntiger server board (openplotter-MCS) and the Moitessier hat installed, I think there is a conflict with SPI ... I hope it settles everything when you develop "OpenPlotter MY APP" and in the meantime Rocco release the updated firmware ... and so? Look down:
"Moitessier HAT is attached.
I2C is enabled.
SPI is disabled. Please enable SPI interface in Preferences -> Raspberry Pi configuration -> Interfaces.
Moitessier HAT package is installed.
Package: moitessier
Status: install ok installed
Maintainer: Thomas POMS <hwsw.development@gmail.com>
Architecture: armhf
Version: 1.20190925-1-4.19.75-1.3.1
Description: Moitessier HAT (AIS/GNSS navigation)
This package provides all the relevant tools, binaries and scripts to communicate, control and update the Moitessier HAT.
Homepage: https://www.rooco.eu"
Have you enabled SPI in Preferences -> Raspberry Pi configuration -> Interfaces?
I have not tested openplotter-MCS yet, I need to finish the openplotter basics before, but Moitessier hat (SPI0) and MCS board (SPI1) are using different SPI interfaces and it should not be a problem at all.
Ciao, yes SPI is enable in preference ...