2016-11-08, 10:03 AM
Quote:(2016-11-07, 05:36 PM)Tigress Wrote: I have a similar question. I am running v0.8 and all appears to be working on my RPi 3. Question is how to configure the multiplexer to send the multiplexed '183 data - via the Openplotter AP - to another client (say, iPad or laptop) running on the same network? Do I need to add ahhn additional TCP output to specify an IP address, say, 10.1.1.0? It would seem that the output that is automatically added at install is localhost only, and would work for the RPI but not across the network? Thanks, and really appreciate the fine work in Openplotter!
If your device and openplotter are logged onto the same network then have a look on the right hand side of the access point tab, there are other ip addresses there you can use. Mine is 192.168.43.147:10110