2019-09-29, 12:09 PM
Finding my way around Signal K, for the first time, using Op2, Cpn5 and Buster.
I have the data from my usb gps and imu into Signal K. I get the gps data on cpn5 but not imu data. Cpn5 connection is set to TCP 10.10.10.1 port 10110. Signal K server for the imu is set to UDP port 52000, I have tried other settings unsuccessfully, any guidance would be appreciated.
As an aside, just had a weeks sailing on a friends yacht, rpi 3b+ Op1.2 Cpn5. For the first time got my basic usb sdr working properly using a homemade 1/4 wave aerial about 2m above the deck and was able see target data up to two miles distant. I think this was probably due to calibration at sea using Op1.2 sdr rather than the Cpn sdr setup.
I have the data from my usb gps and imu into Signal K. I get the gps data on cpn5 but not imu data. Cpn5 connection is set to TCP 10.10.10.1 port 10110. Signal K server for the imu is set to UDP port 52000, I have tried other settings unsuccessfully, any guidance would be appreciated.
As an aside, just had a weeks sailing on a friends yacht, rpi 3b+ Op1.2 Cpn5. For the first time got my basic usb sdr working properly using a homemade 1/4 wave aerial about 2m above the deck and was able see target data up to two miles distant. I think this was probably due to calibration at sea using Op1.2 sdr rather than the Cpn sdr setup.