2020-01-14, 12:01 PM
Just did a semi- full re-install: Uninstalled all OpenPlotter apps, and installed again. (is there a full reset option? For some reason bits of the configuration seemed sticky..)
Much better this time around- at least I am getting compass, heel and pitch data as well as temp and pressure.
Interestingly the temp is a fixed 20C, the pressure a fixed (forgaot hte value) mbars. Temp according to the moitessier app would ne in the 40C range- am I getting debug / simulated data?
The compass, pitch and heel kept changing, adding approximately 1 degree per few seconds (each!) I thought it might be a calibration issue, but could not find a calibrate option anywhere. Slowly turning it around an axis did not stop the slow climb of the readings.
Maybe I'll do a full re-install with the reconfigured Moitessier build later.
Much better this time around- at least I am getting compass, heel and pitch data as well as temp and pressure.
Interestingly the temp is a fixed 20C, the pressure a fixed (forgaot hte value) mbars. Temp according to the moitessier app would ne in the 40C range- am I getting debug / simulated data?
The compass, pitch and heel kept changing, adding approximately 1 degree per few seconds (each!) I thought it might be a calibration issue, but could not find a calibrate option anywhere. Slowly turning it around an axis did not stop the slow climb of the readings.
Maybe I'll do a full re-install with the reconfigured Moitessier build later.