This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
update motor controller
#8
(2020-01-13, 04:54 PM)seandepagnier Wrote: the only problem with potentiometers is most are rated only 10,000 cycles.   Every time the rudder changes direction is a new cycle, which is not very long at sea.   You can get much more expensive ones rated up to 10 million cycles which would be good for years?   hall sensors are actually cheaper and easier to waterproof and don't wear out.

ya a spent a $20 Canadian. i will check out a hall sensor i was going to pot the the unit after it is setup. could you recommand 1 it needs to be small ie under 17mm.
Reply


Messages In This Thread
update motor controller - by ddelorme - 2020-01-11, 05:19 PM
RE: update motor controller - by seandepagnier - 2020-01-12, 03:58 AM
RE: update motor controller - by ddelorme - 2020-01-12, 01:29 PM
RE: update motor controller - by ddelorme - 2020-01-12, 08:24 PM
RE: update motor controller - by seandepagnier - 2020-01-13, 02:36 AM
RE: update motor controller - by ddelorme - 2020-01-13, 02:15 PM
RE: update motor controller - by seandepagnier - 2020-01-13, 04:54 PM
RE: update motor controller - by ddelorme - 2020-01-14, 11:37 AM
RE: update motor controller - by seandepagnier - 2020-01-14, 11:50 PM
RE: update motor controller - by ddelorme - 2020-01-15, 03:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)