|
update motor controller
|
2020-01-15, 03:53 PM
hmmmm looks good i could just mount a magnet on the top of the pintel and mount the sensor in a small case.. could you send me your prototype file. I just read though the specs pdf quickly. I have an ender 3 and use freecad. my space is limited as i have a transom mounted rudder and 9.9 honda outboard, ladder and backstay. i will have to modify the file as it will have to fit on the transom under the tiller.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
update motor controller - by ddelorme - 2020-01-11, 05:19 PM
RE: update motor controller - by seandepagnier - 2020-01-12, 03:58 AM
RE: update motor controller - by ddelorme - 2020-01-12, 01:29 PM
RE: update motor controller - by ddelorme - 2020-01-12, 08:24 PM
RE: update motor controller - by seandepagnier - 2020-01-13, 02:36 AM
RE: update motor controller - by ddelorme - 2020-01-13, 02:15 PM
RE: update motor controller - by seandepagnier - 2020-01-13, 04:54 PM
RE: update motor controller - by ddelorme - 2020-01-14, 11:37 AM
RE: update motor controller - by seandepagnier - 2020-01-14, 11:50 PM
RE: update motor controller - by ddelorme - 2020-01-15, 03:53 PM
|
