This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[OP2] Changing units for temperature and pressure
#1
I know I could change temp to Celsius and pressure to hPa on OP 1.x but cannot find where I can change the units settings in OP2 anymore. 
rpi3 - OP2.0.22stable
Sensor MS5607-02BA03

Any advise? - Thanks!
Reply


Messages In This Thread
[OP2] Changing units for temperature and pressure - by SkipperEarly - 2020-01-13, 03:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)