This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sheet-to-tiller
#5
I'm going to investigate further what can be done with sheet data. I ordered the load cell and the board mentioned in my first post.

Also, I was just graciously granted access to a wind databank from the data science department of the University of Bergen. Wind data is taken from an offshore platform with a variety of sensor (LIDAR and ultrasonic) - has been since 2015 if I understand correctly. I'll look into ways of modeling it to serve the purpose of understanding how sheet data could be used to increase the efficiency of an autopilot.
"Overthinking, I try very hard not to do that."
Reply


Messages In This Thread
Sheet-to-tiller - by Nee-Wom - 2020-01-27, 09:13 PM
RE: Sheet-to-tiller - by seandepagnier - 2020-01-28, 01:02 AM
RE: Sheet-to-tiller - by Nee-Wom - 2020-01-28, 06:09 PM
RE: Sheet-to-tiller - by seandepagnier - 2020-01-29, 01:14 AM
RE: Sheet-to-tiller - by Nee-Wom - 2020-01-31, 07:32 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)