2020-02-06, 02:00 AM
I wired in my old Adifruit 9DOF ( https://www.adafruit.com/product/1714 ) from 2017 and started pypilot. It recognized the device right away. Starting the acceleration calibration I was amazed at how jittery it was. The older Adafruit IMU, generates a lot of green dots just sitting on the bench, so I really don't want to use it after all. That brought up a question.
How do I clear the calibration between one IMU and another?
The reset/clear buttons on the GUI don't seem to work. So I ended up removing and reinstalling pypilot to clear the settings.
Also who sells a 9255 IMU? If my compass freaks out again I may want to try another one anyway. There are some on ebay for $4, but are they reliable ?
How do I clear the calibration between one IMU and another?
The reset/clear buttons on the GUI don't seem to work. So I ended up removing and reinstalling pypilot to clear the settings.
Also who sells a 9255 IMU? If my compass freaks out again I may want to try another one anyway. There are some on ebay for $4, but are they reliable ?