i2c without Mointessier hat

[carlos-palma]

Edit /home/pi/.openplotter/openplotter.conf and remove everything under the tag [I2C]

That is your IMU but what is your pressure sensor? check the detected addresses when you can open the I2C app

Thanks, now I2C works and detects the pressure, temperature and humidity as BME280 0/1/2. The pressure is displayed by Open CPN but not the air temperature, will keep checking.

Thanks, that was the problem!!

---

Edit /home/pi/.openplotter/openplotter.conf and remove everything under the tag [I2C]

That is your IMU but what is your pressure sensor? check the detected addresses when you can open the I2C app

Thanks, now I2C works and detects the pressure, temperature and humidity as BME280 0/1/2. The pressure is displayed by Open CPN but not the air temperature, will keep checking.

Thanks, that was the problem!!

Hi!

Change Signal K Key "environment.inside.temperature" to the key "environment.outside.temperature"

select line 1 BME280 > then  Edit button

In the new box select Edit button

in the new box select in 'group' > "environment" ,in 'Keys' "outside.temperature"  >OK to go back

>OK to go back

Carole

Thanks Carole, that made it work!!
Best, Carlos.