(2020-02-27, 07:06 PM)Sailoog Wrote: remove the sensor from the I2C app and go to moitessier app.
click on "check pressure", what happens?
Temp is OK, pressure gives me en empty </> window..
It's on driver version 4.19.97_1.6.0
Configuration check for Pressure - Temperature:
I2C - Signal K key for pressure: none
I2C - Signal K key for temperature: none
Connection: not connected
System check:
Moitessier HAT is attached.
I2C is enabled.
SPI is enabled.
Moitessier HAT package is installed.
Package: moitessier
Status: install ok installed
Maintainer: Thomas POMS <hwsw.development@gmail.com>
Architecture: armhf
Version: 1.6.0
Description: Moitessier HAT (AIS/GNSS navigation)
This package provides all the relevant tools, binaries and scripts to communicate, control and update the Moitessier HAT.
Homepage: https://www.rooco.eu
<edit>
After re-adding the sensor to I2C, the config for Pressure - Temperature is again:
I2C - Signal K key for pressure: environment.outside.pressure
I2C - Signal K key for temperature: environment.outside.temperature
Connection: Signal K connection ID = I2C
Signal K to NMEA 0183 plugin: enabled
Pressure conversion: enabled
</edit>
Lemon?