2016-12-15, 07:02 PM
Network is very difficult and has changed on many places in Raspbian in 2016.
It would be great if you could setup your access point and bridges with the network manager.
But you can't. So we use the old way. By doing this the network manager is disabled for these ports. It is every time disabled for the eth0.
The behavior of the eth0 is:
If bridge is disabled. It works as a dhcp client and supports the bonjour protocol.
If bridge is enabled. It works as a dhcp server with the same IP as the access point (10.10.10.1)
You can access a headless RPI everytime on eth0 with openplotter.local or 10.10.10.1 if there is a problem with the wlan (access point).
See also: https://sailoog.gitbooks.io/openplotter-...fi-ap.html
It would be great if you could setup your access point and bridges with the network manager.
But you can't. So we use the old way. By doing this the network manager is disabled for these ports. It is every time disabled for the eth0.
The behavior of the eth0 is:
If bridge is disabled. It works as a dhcp client and supports the bonjour protocol.
If bridge is enabled. It works as a dhcp server with the same IP as the access point (10.10.10.1)
You can access a headless RPI everytime on eth0 with openplotter.local or 10.10.10.1 if there is a problem with the wlan (access point).
See also: https://sailoog.gitbooks.io/openplotter-...fi-ap.html