This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
pypilot disconnected at startup - Steps toward troubleshooting?
#1
I have RPi 3B+ running openplotter 1.2 and sean's motor controller.  The autopilot worked successfully while testing, but I broke it sometime while adding a USB serial AIS receiver and changing around GPIO assignments for my panel control.

Now on boot, sensors are working but both the OpenCPN plugin and the openplotter pypilot autopilot control show "disconnected".  Restarting signal K does not help.  Changing /dev/ttyOP_ap assignment to none, apply, then back to pypilot brings autopilot control back to life.

How do I go after this?
Reply


Messages In This Thread
pypilot disconnected at startup - Steps toward troubleshooting? - by AlanH - 2020-03-22, 05:54 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)