2020-05-11, 12:33 PM
I apologize, if this has been discussed before.
I just received my second mpu9255 sensor, since the one before was faulty.
So I connected it to the rpi according to the manuals and it shows and I can calibrate (sort of) it using pypilot...
When I look at it in signal K instrumentpanel it only gives out pitch and roll... the yaw is blank... I fear that's not how it is supposed to do?
Also... the magnetic heading is not acting like I'd expect... the heading doesn't change according to how I am...
I must be doing something wrong, what might it be?
I'm a total beginner and appreciate feedback and help
Cheers
Roy
I just received my second mpu9255 sensor, since the one before was faulty.
So I connected it to the rpi according to the manuals and it shows and I can calibrate (sort of) it using pypilot...
When I look at it in signal K instrumentpanel it only gives out pitch and roll... the yaw is blank... I fear that's not how it is supposed to do?
Also... the magnetic heading is not acting like I'd expect... the heading doesn't change according to how I am...
I must be doing something wrong, what might it be?
I'm a total beginner and appreciate feedback and help
Cheers
Roy