2016-04-20, 12:16 PM
SOLVED: I measured the resistance and voltage between the VIN/GND and SDA/SLA and found values to indicate that the sensor is not burned. I then un-soldered and resoldered the sensor into the base. Obviously I had a shortage between SDA/SLC which caused the strange behaviour.
Calibration: I assume sensors are already calibrated and do not need to be re-calibrated - wouldn't even know how to do this, as no such option is in the gui.
Calibration: I assume sensors are already calibrated and do not need to be re-calibrated - wouldn't even know how to do this, as no such option is in the gui.