2022-10-01, 11:58 AM
(2022-10-01, 10:02 AM)schrammie Wrote: sailoog
thanks for reply. YES and no for updating my system. After a long time iam getting a little bit hold on working with the rapsberry pi. Iam running openplotter on a SSD and that too take a long time to get it working (problebly my newby experience with raspberry pi). So iam afraid to do it all over again. Little bugs are still showing for example i still dont get my BME280 or the HTU21D on signal k but i can see them on i2c. In stead i put a BMP280 (without humity) and that's running fine also in signal K.
It is stable for now and i can import Grafana into KIP dasboard. So i think i will have it running for the time being.
My total system is:
Raspberry pi 4 8gb with SSD running on openplotter
Pican-m (to nmea 2k and nmea 0183)
RTL-SDR with miniwhip and fldigi and GQrx
16 inch touchscreen Aoc
victron shunt with USBcable
BMP280 and MPU 9250 (pypilot)
1-wire with serveral DB temp sensors
Still working on getting my old Yanmar 2GM20 by or arduino or ESP32 to rapsberry pi.( temp oilpressure RPM, etc)
Thansk a lot for the great work!!!
renze
easy to just use a spare SD card & try a fresh install with ssd disconnected.
Might be a good idea to track down whatever is wrong now rather than later..