2021-03-20, 08:25 AM
(2021-03-19, 11:12 PM)Sea-and-Sea Wrote: Hey guys, my current setup:You might usefully refer to : https://forum.openmarine.net/showthread.php?tid=3331
Raspberry pi4
Moitessier hat 2
Openplotter lates version
Opencpn 5.2.4
FTDI USB nmea 0183 TX/RX stick
I'm trying to output GPS/GNSS from the Moitessier hat to nmea 0183 using the USB stick to my VHF radio that has nmea0183 input
in Openplotter Serial setup:
device ttyUSB0
alias ttyOP_nmea
data nmea 0183
connection SignalK
id nmea
baud 38400
in Opencpn connections setup:
type Network
Direction Output
Protocol UDP
Network address 0.0.0.0
Network Port 10119
Priority 1
type Network
Direction Input
Protocol Signal K
Network address local host
Network port 3000
Priority 1
type Network
Direction Output
Protocol UDP
Network address 0.0.0.0
Network port 10110
Priority 1
type Network
Direction In/Out
Protocol UDP
Network address 0.0.0.0
Network port 10119
Priority 1
Signal K config
ID opencpnOUT
data type nmea0183
NMEA0183 Source UDP
Port 10119
Sentence Event nmea0183out
ID nmea
data type nmea0183
NMEA0183 Source Serial
Serial port /dev/ttyOP_nmea
Baud rate 4800
Output Events nmea0183out
Sentence Event nmea0183out
the VHF radio says "no gps signal"
When i run 'cat /dev/ttyOP_nmea' i get no output reported (same on cat /dev/ttyUSB0
I think i've followed instructions in OpenPlotter, OpenCPN and Moitessier and can't see what i'm doing wrong.
Any help greatly appreciated
Thanks
Colin
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you