2017-03-14, 09:42 AM
(This post was last modified: 2017-03-14, 09:46 AM by Littlechay.)
Yes I confirm the same behavior as the OP.
1W sensor with OP set to trigger on 290K (I have the temperature displaying in signal K in C but for some reason the action still sees the original K value).
Action is to raise a GPIO pin high - this operates a relay that drives a relay and LED
a 2nd trigger is set for <= 290K with the action to set the GPIO pin low
Restarting with the trigger condition active causes immediate 100% cpu hang
but a couple restarts with the the trigger condition not met i.e. the temperature lower than trigger seems to result in normal function.
Anything I can do to help debug?
Edit: SystemÂ
RPI 3 with official 7" touch screen
A mini USB keyboard
GPS HAT
IMU9, pressure, temp, humidity, 1W temp probe
OP alpha 0.9 downloaded from here and updated/upgraded as per discussions in this forum.
1W sensor with OP set to trigger on 290K (I have the temperature displaying in signal K in C but for some reason the action still sees the original K value).
Action is to raise a GPIO pin high - this operates a relay that drives a relay and LED
a 2nd trigger is set for <= 290K with the action to set the GPIO pin low
Restarting with the trigger condition active causes immediate 100% cpu hang
but a couple restarts with the the trigger condition not met i.e. the temperature lower than trigger seems to result in normal function.
Anything I can do to help debug?
Edit: SystemÂ
RPI 3 with official 7" touch screen
A mini USB keyboard
GPS HAT
IMU9, pressure, temp, humidity, 1W temp probe
OP alpha 0.9 downloaded from here and updated/upgraded as per discussions in this forum.