2016-04-21, 04:13 PM
Hi
I'm still experimenting with the openplotter serial outputs using the pi gpio
i've connected a gps on the gpio serial input using the adafruit tutorial (see my previous post)
Now i'm trying to connect my PC to the gpio serial output ( I use specific navigation software on my PC which cannot use nmea over tcp)
The hardware is simple: an ftdi usb to serial converted connected to GPIO TX end 0
It actually works with openplotter nmea inspector running but stalls if i pause or stop the inspector
any idea's how to fix this
I'm still experimenting with the openplotter serial outputs using the pi gpio
i've connected a gps on the gpio serial input using the adafruit tutorial (see my previous post)
Now i'm trying to connect my PC to the gpio serial output ( I use specific navigation software on my PC which cannot use nmea over tcp)
The hardware is simple: an ftdi usb to serial converted connected to GPIO TX end 0
It actually works with openplotter nmea inspector running but stalls if i pause or stop the inspector
any idea's how to fix this