2017-04-17, 02:49 PM
(2017-04-13, 04:29 PM)Sailoog Wrote: sure: https://github.com/sailoog/openplotter/b...ANGELOG.md
GPIO sensors have already been fixed so your motion sensor will work. The problem is that actions are not working yet.
I guess GPIO sensors is the same as the formly named GPIO switches?
How can check a configured input sensor? In 0.8 I could see a working switch in the NMEA inspector.
In 1.0.2 I tried Signal K diagnostic without success.
But without Actions a Motion sensor is useless, isn't it? Or is there a workaround?
Best regards,
Martin