2023-07-10, 10:34 AM
Hi all
I have an open plotter instance running for over a year and covered about 600 miles as my only plotter.
The pi has an SSD for storage, and connetions to a U-blox and some USB connections (primarially a USB SDR to run as an AIS reciever)
Power is delivered direct to the IO ports with a buck converter.
I do have a small issue.
Open CPM sometimes crashes (the wait/force quit popup) when the engine is started. Other services seem fine and browsing and stuff does not miss a beat.
I dont have any sensors connected to the engine.
I dont know if its EMF or bad power (or something else!). Any ideas what I can do to fix this? My usual process is to shutdown the open plotter, start the engine, and bring the plotter back - but that is a bit of a Kludge.
I also recently got a Standard Horizon VHF (with AIS reciever) that I hope to connect, but dont want to start that without fixing the other issue first.
Regards
John FJ
Regards
John F J
I have an open plotter instance running for over a year and covered about 600 miles as my only plotter.
The pi has an SSD for storage, and connetions to a U-blox and some USB connections (primarially a USB SDR to run as an AIS reciever)
Power is delivered direct to the IO ports with a buck converter.
I do have a small issue.
Open CPM sometimes crashes (the wait/force quit popup) when the engine is started. Other services seem fine and browsing and stuff does not miss a beat.
I dont have any sensors connected to the engine.
I dont know if its EMF or bad power (or something else!). Any ideas what I can do to fix this? My usual process is to shutdown the open plotter, start the engine, and bring the plotter back - but that is a bit of a Kludge.
I also recently got a Standard Horizon VHF (with AIS reciever) that I hope to connect, but dont want to start that without fixing the other issue first.
Regards
John FJ
Regards
John F J