2023-08-25, 09:38 PM
Hi All,
I am working on hooking up an ADS1015s to the I2C bus in Openplotter 3. The I2C app finds it just fine. Permission is granted for Signalk so that is all good. When I go to the setup for the ADS1015 if I click include raw data I see the data come into Signalk. If I don't click include raw data I get "null". It appears I need to understand what goes in the settings for the ADS1015. As installed it has "Range1 = 0|1700-> 0|16" which I assume is a setup for the ADS1015 config register but I can't seem to correlate this with fields in the register. nor do I know what Range1 is.
Is there a decoder ring for this setup? I could just work with the raw data but I would like to use the scaling features. Thanks for any help on this.
I am working on hooking up an ADS1015s to the I2C bus in Openplotter 3. The I2C app finds it just fine. Permission is granted for Signalk so that is all good. When I go to the setup for the ADS1015 if I click include raw data I see the data come into Signalk. If I don't click include raw data I get "null". It appears I need to understand what goes in the settings for the ADS1015. As installed it has "Range1 = 0|1700-> 0|16" which I assume is a setup for the ADS1015 config register but I can't seem to correlate this with fields in the register. nor do I know what Range1 is.
Is there a decoder ring for this setup? I could just work with the raw data but I would like to use the scaling features. Thanks for any help on this.