This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tiny pilot > signalk connection & accel calibration
#7
Think it loads on boot now. From https://forum.openmarine.net/showthread....7#pid23717 ..

I went into tinypilot over ssh, user tc, password pypilot then
Code:
sudo nano   /opt/bootlocal.sh 

added  python3.8-urllib3 python3.8-chardet python3.8-certifi python3.8-idna to the  # start pypilot section 

now looks like>
Code:
date
echo 'loading pypilot drivers'
time chpst -utc tce-load -is $PYTHON-serial $PYTHON-RTIMULib $PYTHON-ujson liblzma libudev $PYTHON-pyudev $PYTHON-six pypilot python3.8-urllib3 python3.8-chardet python3.8-certifi python3.8-idna
then
filetool.sh -b
to save the changes to disk.

Now after rebooting tinypilot it creates a websocket in signalk (after device added read/write) and send pitch/roll7yaw & heading data.
YAY!!  Big Grin
Reply


Messages In This Thread
RE: Tiny pilot > signalk connection & accel calibration - by PaddyB - 2023-09-27, 08:09 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)