2023-11-03, 04:28 PM
Did the testing today and the log value is now correct.
A few observations though concerning the Instrumentpanel.
The boat is stationary, no movements.
After Seatalk1 startup the IP shows correct values for the log (11451) and the trip (0.0).
After a few minutes the datagram 0x25 changes to "0x25 0x00".
About at this moment the IP starts to show a value "null" for the log and the trip.
The ST1 instruments still maintain the correct values for the log (11451) and the trip (0.0).
Is it possible to discard the datagram "0x25 0x00" and use the "last known sensible value" for the log and the trip?
Noted also that the trip-widget does not show the value unit in the lower right corner.
Also it does not have a unit selection at all (metres, nautical miles).
If I recall correctly it seemed to show the trip-value in metres.
Is there a way to correct these ?
But thanks a bunch for the log value correction !!
Cheers,
tjm
A few observations though concerning the Instrumentpanel.
The boat is stationary, no movements.
After Seatalk1 startup the IP shows correct values for the log (11451) and the trip (0.0).
After a few minutes the datagram 0x25 changes to "0x25 0x00".
About at this moment the IP starts to show a value "null" for the log and the trip.
The ST1 instruments still maintain the correct values for the log (11451) and the trip (0.0).
Is it possible to discard the datagram "0x25 0x00" and use the "last known sensible value" for the log and the trip?
Noted also that the trip-widget does not show the value unit in the lower right corner.
Also it does not have a unit selection at all (metres, nautical miles).
If I recall correctly it seemed to show the trip-value in metres.
Is there a way to correct these ?
But thanks a bunch for the log value correction !!
Cheers,
tjm