This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sense Hat
#11
(2017-09-30, 11:30 PM)Leigh Wrote:
(2017-05-30, 06:34 PM)Sailoog Wrote: About sense hat.

All sensors are supported by OP but...
I agree, having the magnetometer so close to the raspberry and electrical components should not be good.
Calibrating the IMU plugged to the raspberry can be difficult too.
Pressure, humidity and temperature will be affected by raspberry too. And that will be worse if your enclosure is sealed because pressure will be always the inside pressure.
I have not tested anything, just thoughts...

Hello everyone,
I have a few RPi's and a sense hat and am just looking into OP, which seems amazing

I have used the sense hat before and to get around the heating issue I just used a ribbon cable to move it away from the Pi.
The advantage of the SH for me is that (other than I already have it) is it has all sensors on it.
Perhaps the LED could be used for an down below display of something(s) too?
I am headless with VNC on tablet, Phone or whatever.


However, I am having problems getting the temp, press, hygro, heel and pitch showing in the Dashboard, despite the fact that I know the sensors are being seen as I can see there values in the Calibrate window. (and in 0.8 the boat cursor would rotate as I rotated the Pi, although this does not happen in 0.10)

Could anyone give me a step by step from the basics way of doing this?
I saw http://forum.openmarine.net/showthread.p...ight=graph but it made absolutely no sense to me, except for perhaps I have to rename the sensors somewhere?

Thanks

Sorted with great help:
http://forum.openmarine.net/showthread.p...60#pid3160
Reply


Messages In This Thread
Sense Hat - by ygageot - 2017-05-19, 10:11 AM
RE: Sense Hat - by abarrow - 2017-05-21, 12:13 AM
RE: Sense Hat - by tocan - 2017-05-21, 12:29 PM
RE: Sense Hat - by ddelorme - 2017-05-24, 11:45 AM
RE: Sense Hat - by tocan - 2017-05-24, 01:39 PM
RE: Sense Hat/pico 3.0a plus - by ddelorme - 2017-05-29, 11:15 AM
RE: Sense Hat - by tocan - 2017-05-29, 11:21 AM
RE: Sense Hat - by ygageot - 2017-05-29, 01:20 PM
RE: Sense Hat - by Sailoog - 2017-05-30, 06:34 PM
RE: Sense Hat - by Leigh - 2017-09-30, 11:30 PM
RE: Sense Hat - by Leigh - 2017-10-03, 09:33 AM
RE: Sense Hat - by ddelorme - 2017-10-03, 11:08 AM
RE: Sense Hat - by Leigh - 2017-10-03, 12:37 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)