This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Create action from switch attached to GPIO
#9
(2017-05-24, 03:13 AM)Littlechay Wrote: Any ideas anybody? Frustrating this, so close but no bananas!

Seems to work OK if you create a little bash script then run that from an openplotter command:

The screen grabs are with an action based on engine.temp greater than 0 but I've just tested it triggered by a gpio pin pulled to ground which seems to work fine as well. 

Good idea!!! 

[Image: 3tKs1Si.png]

[Image: oFephgi.png]
Reply


Messages In This Thread
RE: Create action from switch attached to GPIO - by PaddyB - 2017-05-24, 10:02 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)