This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
I2C and Raspberry Pi5

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
I2C and Raspberry Pi5
Opie91 Offline
Member
***
Posts: 173
Threads: 15
Joined: Jun 2017
Reputation: 6
#1
2024-02-24, 03:48 AM
Has anyone else noticed that the Pi5 does not seem to be as good as the Pi4 with I2C? It seems not to tolerate much more than about 200 mm of a wire run or a large number of devices. As I added more devices the length of the run needed to be shorter.

Adding an Adafruit LTC 4311 Active I2C terminator resolved the issue.
Find
Reply


Messages In This Thread
I2C and Raspberry Pi5 - by Opie91 - 2024-02-24, 03:48 AM
RE: I2C and Raspberry Pi5 - by Techstyle - 2024-02-25, 06:14 PM
RE: I2C and Raspberry Pi5 - by Opie91 - 2024-02-26, 11:11 PM
RE: I2C and Raspberry Pi5 - by Adrian - 2024-03-07, 07:51 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)