Sorry I know this may be a generic OpenCPN question but I feel I'm amongst friends here
I am "field testing" my OP installation on my boat and so far its all working just great however I cant get waypoint/route data out to my Autopilot.
My Autopilot is displaying Lat/Long & COG/SOG so the serial interface is working but I don't see distance and bearing to waypoint and the autopilot sentences RMB or APB are not in the NMEA data stream as seen in NMEA Inspector.
I do have an active route and the OCPN window pops up with Range and bearing to waypoint etc but it doesn't appear as an RMB sentence in the NMEA stream.
Any ideas ?
Thanks
Steve
Oh bye the way does it matter if I'm COG or SOG to speak of ?
I am "field testing" my OP installation on my boat and so far its all working just great however I cant get waypoint/route data out to my Autopilot.
My Autopilot is displaying Lat/Long & COG/SOG so the serial interface is working but I don't see distance and bearing to waypoint and the autopilot sentences RMB or APB are not in the NMEA data stream as seen in NMEA Inspector.
I do have an active route and the OCPN window pops up with Range and bearing to waypoint etc but it doesn't appear as an RMB sentence in the NMEA stream.
Any ideas ?
Thanks
Steve
Oh bye the way does it matter if I'm COG or SOG to speak of ?