This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hanging when trying to start OpenPlotter when trying to use openGL
#5
Hi Chris,

I'm facing the same problems, you described in your 1st post.
Did you finally succeed in using opencpn with OpenGL enabled on your raspberry pi3?
And if so: what did you do?
I tried Full- as well as Fake-KMS-Driver - the results are always frustrating (opencpn freezes randomly, sometimes open plotter hangs while checking 480x800-resolution).
Any tip would be appreciated!

Thx in advance - and happy new year!
Uli
Home is, where the anchor drops.
Reply


Messages In This Thread
RE: Hanging when trying to start OpenPlotter when trying to use openGL - by SkipUli - 2018-01-01, 04:48 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)