2017-09-17, 07:19 PM
The bidirectional NMEA0183 connection works.
I tested this configuration on kplex.conf:
[tcp]
name=sm
direction=both
optional=yes
mode=client
persist=yes
retry=10
address=192.168.8.3
port=10110
ifilter=+II***:-all
ofilter=+OC***:-all
If I put it in the GUI settings section, the openplotter recognizes it.
The diagnostic also visulizes input and output:
the edit window displays the settings but can not be changed because they would be rewritten incorrectly:
Even the Disable button can not be used because it changes the settings.
I think with a few changes to the software can be managed all properly, as is the case with kplex.
I tested this configuration on kplex.conf:
[tcp]
name=sm
direction=both
optional=yes
mode=client
persist=yes
retry=10
address=192.168.8.3
port=10110
ifilter=+II***:-all
ofilter=+OC***:-all
If I put it in the GUI settings section, the openplotter recognizes it.
The diagnostic also visulizes input and output:
the edit window displays the settings but can not be changed because they would be rewritten incorrectly:
Even the Disable button can not be used because it changes the settings.
I think with a few changes to the software can be managed all properly, as is the case with kplex.