2016-05-02, 10:54 AM
(2016-05-01, 11:29 PM)holgerw Wrote: you can only connect with one device to the gps.
try to shut off all other devices the gps was connected before.
bluetooth gps was is a little tricky.
i will send you my solution.
after adding this,
the serial connection was well for me after every restart.
# sudo nano /etc/rc.local
add lines like this at the end with the MAC Adresses of your BT gps!
# bluetooth gps
rfcomm bind 0 00:15:4B:11:1A:95
#rfcomm bind 2 20:13:07:31:20:47
rfcomm bind 1 20:13:07:31:19:51
#rfcomm bind 3 00:15:4B:11:1A:95
then the serial stream should get into the rfcomm device, test it with:
cat /dev/rfcomm0
Hi, thanks a lot
Maybe I didn't understood!!!
I delete all the connection in openplotter setting and I add a new one for GPS BT
I tried to add those line
# bluetooth gps
rfcomm bind 0 00:02:C7:15:94:34
#rfcomm bind 2 00:02:C7:15:94:34
rfcomm bind 1 00:02:C7:15:94:34
#rfcomm bind 3 00:02:C7:15:94:34
in
sudo nano /etc/rc.local
But nothing happened
I tried also to add those line in open plotter advanced setting, but nothing happened...
I tried to give command "cat /dev/rfcomm0" before and after to give "sudo rfcomm connect 0 00:02:C7:15:94:34 &"
I'm quite lost
Mauro