(2017-10-09, 06:06 PM)Sailoog Wrote: ops, yes updating from 0.10.0 takes a long time and lots of bytes. Most of your packages are already updated so you would not need more than 100 MB. This number is not accurate, I do not want you to run out of traffic, Can you take tour system to any wifi?
The update is ready, you should be able to do it now.
Again, thanks a lot! Just triggered the update. After a minute or so, the RDP session was closed and cant be reestablished, so i cant see the Progress. I can VNC-in, but as it is another session, i cant see the progress there too.
But my OP is still running. So i will wait for 30 minutes, hoping the update works unattended. And than restart the Raspy? Or re-Trigger the update via VNC?
THX for your efford, especially in this hard days!
Ok, the good news are: RDP works again. The System now is on 0.16!
The bad news: Still no Signal K keys! But a different error message when restarting Signal K Server, i attach a picture again: