This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Bug Reports v
Lost I2C, 1 wire upgrading to 0.16.0

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Lost I2C, 1 wire upgrading to 0.16.0
holgerw Online
snorkel
****
Posts: 292
Threads: 4
Joined: Mar 2016
Reputation: 9
#4
2017-11-12, 10:45 AM
(2017-11-06, 05:18 PM)Saqqara Wrote: Hardware failure. Bad sda or scl pins on my Pi 3 apparently. That makes two Pi 3's I have with dead GPIO. Pi 2 never fails.


Be carefull not to connect 5V i2c devices to yor pi. Allways use 3,3V or with older i2c chips an Converter!
Donautics
Website Find
Reply


Messages In This Thread
Lost I2C, 1 wire upgrading to 0.16.0 - by Saqqara - 2017-10-23, 12:09 AM
Lost I2C, 1 wire upgrading to 0.16.0 - by holgerw - 2017-11-12, 10:45 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)