(2017-11-25, 12:27 PM)Sailoog Wrote: You can not update to 0.10.0 from 0.8.0
SSH is disabled by default
Are you sure your VNC program is working right and can connect to 10.10.10.1:5900? Do not use RealVNC
If you can not go headless try to start with a monitor to find out what is happening
I will move this post to How do I? forum
Tried TightVNC as well as RealVNC, neither work. Being that the Pi boots into rescue mode that I can see from my serial monitor I don't think anything has installed.
The point I'm getting at is in an emergency/remote location it might be very important to re-install without a screen. Headless install worked on the Pi3, doesn't seem to be working on the Pi2.
I've even disabled the keyboard recovery shift trigger
Code:
quiet ramdisk_size=32768 root=/dev/ram0 init=/init vt.cur_default=1 elevator=deadline silentinstall keyboardtriggerdisable display=2Is there anything else I can change in the recovery.cmdline file to force a install of the /os dir?
Or once I'm in the rescue prompt can I manually install?
Just did a check to make sure it was a Pi2. Looks like it's a Pi1 Rev B. Is there support for this model?
This is from cat /proc/cpuinfo
Code:
processor : 0
model name : ARMv6-compatible processor rev 7 (v6l)
BogoMIPS : 697.95
Features : half thumb fastmult vfp edsp java tls
CPU implementer : 0x41
CPU architecture: 7
CPU variant : 0x0
CPU part : 0xb76
CPU revision : 7
Hardware : BCM2708
Revision : 000e
Serial : 000000006fcfc1ce