This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motor Controller
#2
(12-26-2017, 11:19 AM)NahanniV Wrote: I have a Raymarine type 2 Electro-Hydraulic reversing pump-set.

The spec. says 24A Typical:

http://www.nautimarket.com/documenti/600...124_en.pdf

Can you support this ?

I also have a smaller Type 1 pump-set that is rated 19A as a backup; Possibly I could plumb this in in parallel.

Cheers,
JM.

I am in the progress of building a higher current controller which will be able to support this, but at this time, my current controller is big enough.

The autopilot computer would remain the same.
  Reply


Messages In This Thread
Motor Controller - by NahanniV - 12-26-2017, 11:19 AM
RE: Motor Controller - by seandepagnier - 12-30-2017, 12:09 PM
RE: Motor Controller - by NahanniV - 12-31-2017, 01:08 PM
RE: Motor Controller - by seandepagnier - 01-02-2018, 11:10 AM
RE: Motor Controller - by Ingo - 05-20-2018, 09:04 PM
RE: Motor Controller - by seandepagnier - 05-20-2018, 09:52 PM
RE: Motor Controller - by verkerkbr - 07-31-2018, 04:04 AM
RE: Motor Controller - by seandepagnier - 07-31-2018, 07:44 AM
RE: Motor Controller - by NahanniV - 01-30-2019, 10:36 PM
RE: Motor Controller - by seandepagnier - 01-30-2019, 11:19 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)