This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motor Controller
#4
If over current is detected, the controller will not move in that direction any more. The max current possible in bursts is 20 amps for this controller, and 60 for the new controller.

This is from the drive stalling, typically.

It is different from over-temperature which will occur if the average current is too high and the components heat up. This controller can handle few amps average, the new controller should be able to average 20. In this case, the motor will stop until the controller cools sufficiently.

So, maybe the smaller controller will work, in some conditions with a hydraulic pump (provided it doesn't surge above 20 amps). For example, I average 1/4th watt (makes small adjustment every 15-20 seconds) for in light air and protected waters, vs 4 watts running down wind, with swells.
  Reply


Messages In This Thread
Motor Controller - by NahanniV - 12-26-2017, 11:19 AM
RE: Motor Controller - by seandepagnier - 12-30-2017, 12:09 PM
RE: Motor Controller - by NahanniV - 12-31-2017, 01:08 PM
RE: Motor Controller - by seandepagnier - 01-02-2018, 11:10 AM
RE: Motor Controller - by Ingo - 05-20-2018, 09:04 PM
RE: Motor Controller - by seandepagnier - 05-20-2018, 09:52 PM
RE: Motor Controller - by verkerkbr - 07-31-2018, 04:04 AM
RE: Motor Controller - by seandepagnier - 07-31-2018, 07:44 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)