This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
MPU 9255 Adresse ändern

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
MPU 9255 Adresse ändern
shark24 Offline
Member
***
Posts: 96
Threads: 0
Joined: Apr 2017
Reputation: 4
#3
2018-01-16, 08:10 PM
Quoting the data sheet


Quote:The slave address of the MPU-9255 is b110100X which is 7 bits long. The LSB bit of the 7 bit address is determined by the logic level on pin AD0. This allows two MPU-9255s to be connected to the same I2C bus. When used in this configuration, the address of the one of the devices should be b1101000 (pin AD0 is logic low) and the address of the other should be b1101001 (pin AD0 is logic high).
Find
Reply


Messages In This Thread
MPU 9255 Adresse ändern - by Luckbert - 2018-01-13, 04:57 PM
RE: MPU 9255 change address - by e-sailing - 2018-01-15, 11:01 PM
RE: MPU 9255 change address - by shark24 - 2018-01-16, 08:10 PM
RE: MPU 9255 change address - by Luckbert - 2018-01-17, 06:37 PM
RE: MPU 9255 change address - by shark24 - 2018-01-17, 08:18 PM
RE: MPU 9255 Adresse ändern - by Luckbert - 2018-01-23, 02:24 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)