2018-02-14, 10:39 AM
Chris
I don't actually have my 1W sensors directly attached to my Pi (My 1W sensors are connected to ESP8226 Wireless senders instead) however I did just try to add a 1W in OP (0.17Beta) and it seemed to work OK for me. I was able to open the SignalK Key assignment dialogue box by clicking "edit" and it did give me a list of available SK keys. As I said, I couldn't take it much further as I dont have any 1W sensors attached.
I think your problem is symptomatic of a more general problem in 0.17 which hopefully Sailoog and the developer team are aware of. I say that because I've reported (as a "me too" post) a similar problem with the SPI tab. I cannot edit the SPI device (MCP3008) properties defined in the SPI tab. In the end I removed it by directly editing openplotter.conf however the problem still persists in the OP GUI.
Sorry this doesnt resolve your problem however you are not alone ...
Regards
Steve
I don't actually have my 1W sensors directly attached to my Pi (My 1W sensors are connected to ESP8226 Wireless senders instead) however I did just try to add a 1W in OP (0.17Beta) and it seemed to work OK for me. I was able to open the SignalK Key assignment dialogue box by clicking "edit" and it did give me a list of available SK keys. As I said, I couldn't take it much further as I dont have any 1W sensors attached.
I think your problem is symptomatic of a more general problem in 0.17 which hopefully Sailoog and the developer team are aware of. I say that because I've reported (as a "me too" post) a similar problem with the SPI tab. I cannot edit the SPI device (MCP3008) properties defined in the SPI tab. In the end I removed it by directly editing openplotter.conf however the problem still persists in the OP GUI.
Sorry this doesnt resolve your problem however you are not alone ...
Regards
Steve