This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to get gpio in signal K
#1
Hi everyone,

I have conected a relay on the pi.

I was able to add it in the GPIO tab of OP.
In this window my relay appears in the signal key field :  sensor.relay21

But i am stuck at this point.
- if i go to SK diagnostic it does not appear
- if i go to action and trigger i don't see anything also, and i cannot write in the field "signal K key"

Any idea ?
Reply


Messages In This Thread
How to get gpio in signal K - by topodom - 2018-01-27, 09:29 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)