Posts: 19
Threads: 3
Joined: Apr 2020
Reputation:
0
Didier ==> Do you have a parts list and connections schematic for your set up -- I am embarking on a project to build a Pi based total-boat system that will run OpenCPN/PyPilot as a chartplotter and operate the PyPilot auto-pilot motor controller.
I prefer a one enclosure does it all approach but haven't been a hardware guy since the late-1980s.....when we all built our own desktop machines from boards and hacks.
I would appreciate your sharing your expertise and experience.
Thanks,
Kip Hansen
S/V Golden Dawn
S/V Merlin
kip@i4.net
Posts: 19
Threads: 3
Joined: Apr 2020
Reputation:
0
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
I see that all my questions are answered on the previous page of this forum topic.
Thanks all,
Kip Hansen
S/V Golden Dawn
S/V Merlin
kip@i4.net
Posts: 68
Threads: 11
Joined: Apr 2020
Reputation:
2
When purchasing the MCS board complete with the case, what aditional bits and bobs do you need? I also have the Mortisier Hat on the way.
I know you need the 40 pin adapter and various waterproof glands for cables. Are there waterproof USB and HDMI outlets with short jumper cables? What size standoffs are needed for the Hat?
Posts: 47
Threads: 1
Joined: Feb 2020
Reputation:
0
Good morning Thomas,
I received the MCS pcb, everything ok. Thanks. While I wait to be able to assemble everything, and have permission to access my boat (Covid-19 limitations), I have allowed myself to translate your guide for MCS into Italian. If it could be useful.
Good wind and thank you.
Guida MCS.pdf (Size: 1.27 MB / Downloads: 258)
Comet 1000 - Openplotter under construction
Posts: 42
Threads: 3
Joined: Nov 2019
Reputation:
4
I got my autopilot connected to N0183, Led is lit on the input port (middle right).
In Serial app I've defined SC4 as ttyOP_outpilot
SignalK also shows it, baud rate is correct.
No deltas at all from the input in SignalK
I don't get any input at all, even when doing a cat /dev/ttyOP_outpilot it's all empty.
Any ideas?
Also, do I need to connect the signal gnd? The autopilot doesn't feature a signal gnd connector
Jeanneau Sun Odyssey 42.2 - All Openplottered and hooked up on online.
Posts: 181
Threads: 4
Joined: May 2018
Reputation:
28
what kind of autopilot? NMEA0183 V1 or older ( Means RS422 or toggling 12V??