2020-05-10, 10:07 PM
(This post was last modified: 2020-05-10, 10:51 PM by pi madness.
Edit Reason: Typo and attachments not loading - too big.
)
Hi,
I'm doing a new install running OP2 on a Pi 3B+ with Moitessier HAT. Have followed instructions to get OP2 installed. At one point I changed the SSID and gave it a new password.
I now have the basic network system running but cannot login. The SSID page is back to "openplotter" but default password 12345678 doesn't work. The whole section is greyed out. How can I edit it again and save it permanently?
Meanwhile, on a tablet, using VNC, I can see 10.10.10.1 and the login screen appears but again the password I saved for this connection - it has worked once before, is nolonger working. Again can this be reset?
A third question. In Open Plotter, Networks, there are two icons, one page and pen and the right hand one being a micro SD card. I can guess what they mean but I'd be grateful for clarification of what actually happens.
I'd be very grateful for help with the above questions.
I'm doing a new install running OP2 on a Pi 3B+ with Moitessier HAT. Have followed instructions to get OP2 installed. At one point I changed the SSID and gave it a new password.
I now have the basic network system running but cannot login. The SSID page is back to "openplotter" but default password 12345678 doesn't work. The whole section is greyed out. How can I edit it again and save it permanently?
Meanwhile, on a tablet, using VNC, I can see 10.10.10.1 and the login screen appears but again the password I saved for this connection - it has worked once before, is nolonger working. Again can this be reset?
A third question. In Open Plotter, Networks, there are two icons, one page and pen and the right hand one being a micro SD card. I can guess what they mean but I'd be grateful for clarification of what actually happens.
I'd be very grateful for help with the above questions.