2018-06-12, 01:53 AM
Hello there,
I just got OpenPlotter installed and I don't know what to do next. The documentation seems pretty new and pretty much all pages after the configurations steps are empty.
On the home page, there is an exciting list of features but I can't find anywhere explaining how to use these. For example, I want to set temperature sensors for the engine, water detectors for the bilges, pressure sensor, etc that could display in some windows, or inside OpenCPN in a corner but I have no idea where to start.
Are there any "start here", "tutorials", "what's next" sections or pinned posts somewhere that I failed to see? If not, does anyone have good documentation links, websites or tutorials?
I'm sorry if this was asked before and I didn't see it.
Thanks!
Marco
I just got OpenPlotter installed and I don't know what to do next. The documentation seems pretty new and pretty much all pages after the configurations steps are empty.
On the home page, there is an exciting list of features but I can't find anywhere explaining how to use these. For example, I want to set temperature sensors for the engine, water detectors for the bilges, pressure sensor, etc that could display in some windows, or inside OpenCPN in a corner but I have no idea where to start.
Are there any "start here", "tutorials", "what's next" sections or pinned posts somewhere that I failed to see? If not, does anyone have good documentation links, websites or tutorials?
I'm sorry if this was asked before and I didn't see it.
Thanks!
Marco