2018-04-23, 02:00 PM
Hi, I'm trying to set up a windtrim mode on openplotter. my config is:
autopilot raymarine st1000+
navman wind 3100
openplotter 0.17
RPI3
I connected the autopilot to RPI through this usb to serial adapter
connecting NMEA + (of autopilot) to A/D+ (of usb/serialconverter)
and NMEA - (of autopilot) to B/D- (of usb/serialconverter)
and this is the output of diagnostic:
and I connected the wind instrument to RPI through this usb to serial converter
connecting NMEA OUT (of wind instrument) to pin 2 (of usb/serialconverter)
and GRD (of wind instrument) to pin 5 (of usb/serialconverter)
and this is the output of diagnostic:
from the autopilot manual:
" the recognized Nmea sentences for Apparent wind angle and speed is: VWR"
from the wind instrument manual:
"Nmea 0183 output: MWV,VPW"
Is it correct right now?
What I have to do now?
tnks a lot......
autopilot raymarine st1000+
navman wind 3100
openplotter 0.17
RPI3
I connected the autopilot to RPI through this usb to serial adapter
connecting NMEA + (of autopilot) to A/D+ (of usb/serialconverter)
and NMEA - (of autopilot) to B/D- (of usb/serialconverter)
and this is the output of diagnostic:
and I connected the wind instrument to RPI through this usb to serial converter
connecting NMEA OUT (of wind instrument) to pin 2 (of usb/serialconverter)
and GRD (of wind instrument) to pin 5 (of usb/serialconverter)
and this is the output of diagnostic:
from the autopilot manual:
" the recognized Nmea sentences for Apparent wind angle and speed is: VWR"
from the wind instrument manual:
"Nmea 0183 output: MWV,VPW"
Is it correct right now?
What I have to do now?
tnks a lot......