This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Anyone sending Signal-k from Arduino?
#7
i have an arduino for use with 5v sensors, currently have a mq2 gas sensor, getting the data in node-red, gpio node, and publishing with mqtt node, then in op subscribe mqtt tab and setting message to sk "notifications fire" thats for the digital pin.. then a chart on the dash shows the data of the analog pin as concentration .going to use it in the propain locker.i have another to use as smoke detector or under the stove..
Reply


Messages In This Thread
Anyone sending Signal-k from Arduino? - by LarsD - 2018-02-05, 05:14 PM
RE: Anyone sending Signal-k from Arduino? - by jim321 - 2018-02-16, 09:06 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)