This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
1 wire temp on OpenCPN Dashboard

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
1 wire temp on OpenCPN Dashboard
Chookfoot Offline
Junior Member
**
Posts: 14
Threads: 2
Joined: Oct 2023
Reputation: 1
#1
2023-10-18, 06:31 AM
Hi All,
I am having a bit of a problem that I hope someone here will have a solution to.
I have a Rpi4 b running OpenCPN 5.8.4 and I want to display engine temp on the OpenCPN dashboard. Is there a specific Signal K key that I should use to get it to display ?
I'm using a 1 wire DS18B20 temp sensor. It shows up in the Signal K Data Browser.
I hope I just need the correct SK key.
Thanks in advance.
Find
Reply
Chookfoot Offline
Junior Member
**
Posts: 14
Threads: 2
Joined: Oct 2023
Reputation: 1
#2
2023-10-24, 03:38 AM
OK... Newbie mistake..Decided to use DashboardSK
Cheers!
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)