This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BMP180 Pressure Sensor
#1
I can add the Sensor but I am not able to generate the NMEA 0183 String.

I am not able to set a Group.

Can anybody help me?

I am using the actual Version 0.17.1


Thank you in advance.
Reply
#2
You have to set the sensor on I2C tab to generate signal k data before converting to NMEA 0183
Reply
#3
(2018-03-19, 06:58 PM)Sailoog Wrote: You have to set the sensor on I2C tab to generate signal k data before converting to NMEA 0183

Thank you for reply. I did that already, but i got only 0 Values in the NEMA Stream. AIS is working fine. The Sensor was running well with your Version 0.12.0 . Is it possible that the pi has power issues?


Thank you,

Christian
Reply
#4
(2018-03-20, 09:55 AM)chris3333 Wrote:
(2018-03-19, 06:58 PM)Sailoog Wrote: You have to set the sensor on I2C tab to generate signal k data before converting to NMEA 0183

Thank you for reply. I did that already, but i got only 0 Values in the NEMA Stream. AIS is working fine. The Sensor was running well with your Version 0.12.0 . Is it possible that the pi has power issues?


Thank you,

Christian

here some screenshots:


Attached Files Image(s)
           
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)